At the bottom points of the triangles the rafters meet the top plates of the exterior walls.
Building walls in an attic.
Footnote 12 building envelope assemblies including exterior walls and unvented attic assemblies where used shall comply with the relevant vapor retarder provisions of the 2015 international residential code irc.
If building a knee wall for storage like karl did with this project make sure to insulate that area as well.
To build your walls to the correct length measure the angle of the rafter by laying a piece of 2x4 inch lumber against the side of the rafter in a vertical position.
Step 1 measure the attic.
Knee walls are short wood framed walls that install between the ceiling joists and rafters in an attic.
Don t mash or compress the insulation into the space.
Consult your local building code and inquire about any necessary permits before beginning any such project.
But they are awfully good to have.
Support and follow me.
Footnote 23 envelope leakage shall be determined by an approved verifier using a resnet approved testing protocol.
Use r 30 insulation for the ceiling and r 13 for the walls.
When insulated and covered with drywall the walls improve the thermal envelope of an attic.
Staple insulation between the wall studs and ceiling joists image a.
Framing basics for attic knee walls along the sides of your loft or attic space.
If your attic space is framed with rafters and is unfinished it has a triangular shape.